Slide Lid Opener

Installation Instructions:

To mount this bracket start by mounting the bracket a few feet back from the lid using self-tapping screws(not provided). Ensure that the two base brackets are 23 inches apart. Then mount your actuator to the corresponding A-E installation points(refer to above chart). A-E and 1-17 refers to the size of the bin lid opening. Then install your existing cable to the 1-17, once again referring to the chart. You are now ready to splice your wire on your actuator. Then using a 14 gauge wire run the wire down to your control box. Once your done that, attatch a male three prong that will be plugged into your power supply.